Description
An LWA bearer is a fundamental concept in LTE-WLAN Aggregation (LWA), a feature introduced in 3GPP Release 13 that allows an LTE eNodeB to steer and split user-plane traffic across both the LTE radio interface and a WLAN (Wi-Fi) access point. Unlike simpler interworking schemes such as RAN-level WLAN offloading, where a bearer is moved entirely to WLAN, an LWA bearer keeps its radio protocol stack distributed across both radio links. The Packet Data Convergence Protocol (PDCP) entity resides in the eNB, while the lower layers (RLC, MAC) are instantiated separately on the LTE side and on the WLAN side. This split-PDCP architecture is conceptually similar to dual connectivity, but the secondary path is a WLAN link rather than an LTE secondary cell.
Architecturally, the eNB acts as the anchor node. It hosts the PDCP layer for the LWA bearer and decides how to split PDCP PDUs between the LTE RLC/MAC and the WLAN path. On the WLAN side, a new protocol layer called LWAAP (LTE-WLAN Aggregation Adaptation Protocol), defined in 3GPP TS 36.360, encapsulates PDCP PDUs with a Data Radio Bearer (DRB) identity so that the receiving UE can map them back to the correct bearer. The WLAN termination (WT) node, which may be integrated in the WLAN AP or be a separate entity, forwards these encapsulated packets between the eNB and the UE over the Xw interface. The Xw interface, specified in TS 36.463, 36.464, and 36.465, carries control-plane and user-plane signalling between the eNB and the WT.
From the UE perspective, an LWA bearer is configured by RRC signalling. The UE maintains a single PDCP entity for the bearer and receives PDCP PDUs from two lower-layer paths: the LTE RLC/MAC and the WLAN MAC. Reordering is performed at PDCP to compensate for the different latency characteristics of the two links. This allows the network to opportunistically use WLAN resources when they are available and beneficial, while maintaining the LTE link as the anchor for mobility and control. The bearer can be configured in one of several split modes, including split LWA bearer where traffic is sent over both links simultaneously, and switched LWA bearer where traffic is moved between links.
The LWA bearer concept matters because it enables true radio-level aggregation of licensed and unlicensed spectrum without requiring a full LTE-WLAN interworking gateway. It improves user throughput and network capacity by exploiting Wi-Fi access points that are often underutilized, while keeping the LTE network in control of mobility, security, and QoS. Because PDCP is anchored in the eNB, the bearer benefits from LTE-grade security and header compression, and the WLAN link is treated as a secondary resource rather than an independent access network.
In later releases, the LWA bearer definition remained stable, reflecting the maturity of the feature. Although LWA itself saw limited commercial deployment compared to other aggregation technologies, the bearer concept influenced subsequent work on multi-connectivity and access traffic steering. The LWA bearer remains a useful reference for understanding how 3GPP designs split-bearer architectures across heterogeneous radio accesses.
Purpose & Motivation
The LWA bearer exists to solve the problem of efficiently combining LTE and Wi-Fi radio resources for a single user without breaking the LTE bearer model. Before LWA, WLAN interworking in 3GPP relied on either seamless offloading (where a bearer was moved entirely to WLAN) or non-seamless offloading (where traffic was routed via the core network). These approaches could not simultaneously use LTE and WLAN for the same bearer, and they often introduced core-network signalling overhead or lost LTE-level control. The LWA bearer was created to allow a bearer to remain anchored in the eNB while benefiting from WLAN capacity, preserving LTE security, QoS, and mobility management.
Historically, the motivation came from the explosive growth of mobile data traffic and the widespread availability of Wi-Fi access points. Operators wanted to leverage unlicensed spectrum without deploying complex new core-network nodes. By defining a bearer whose radio protocols are located in both the eNB and the WLAN, 3GPP provided a RAN-controlled aggregation mechanism that could be implemented with modest changes to the eNB and UE. The LWA bearer also addressed the need for tight latency control and reordering, which earlier offload solutions lacked.
The concept paved the way for more advanced multi-connectivity features and demonstrated the feasibility of split-PDCP architectures across heterogeneous links. Although LWA was not widely deployed, the bearer design informed later discussions on 5G multi-access and access traffic steering, making it an important milestone in 3GPP's evolution toward flexible, multi-radio bearer management.
What changed in its specifications
The latest release-to-release comparison of specifications that define LWA bearer. Each summary describes the whole specification, not only this term.
Rel-19 added NTN IoT Phase 3 for LTE, covering regenerative payload S1 removal, Msg3 early data transmission, and ETWS/CMAS for NB-IoT NTN. It also added inter-RAT mobility from E-UTRAN terrestrial network to NR NTN, plus NR NTN feeder link switchover via handover.
Full comparison in TS 36.300 →Rel-19 brings only minor changes to TS 36.323: 0 clauses changed, with no change attributed to a release feature.
Full comparison in TS 36.323 →Release Timeline
Detected Changes Across Releases
from 3GPP Change RequestsSpecific changes extracted from the „Change history“ tables of 3GPP specifications (1 CRs across 1 releases). Complements the general historical overview above with the evidence-based evolution of this function.
Defining Specifications
3GPP specifications that define or reference LWA bearer, with the latest known release. Sourced from the 3GPP document catalog — see methodology.
| Specification | Title | Release |
|---|---|---|
| TS 36.300 vj20 | E-UTRAN Radio Interface Protocol Architecture | Rel-19 read |
| TS 36.323 vj00 | PDCP Protocol Specification | Rel-19 read |
| TS 36.360 vj00 | LTE-WLAN Aggregation Adaptation Protocol | Rel-19 read |
| TS 36.463 vj00 | XwAP Protocol Specification | Rel-19 read |
| TS 36.464 vj00 | Xw Interface User Plane Protocol | Rel-19 read |
| TS 36.465 vj00 | Xw User Plane Protocol Specification | Rel-19 read |