Description
The Phase Tracking Reference Signal (PT-RS) is a physical layer reference signal defined in the 5G New Radio (NR) air interface, starting from 3GPP Release 15. Its primary function is to enable the receiver to estimate and track rapid phase variations, known as phase noise, which can severely degrade the performance of high-order modulation schemes like 256-QAM or 1024-QAM. Phase noise becomes a dominant impairment at higher carrier frequencies (e.g., in the mmWave bands above 24 GHz) and in systems employing high-power amplifiers or complex multi-antenna (MIMO) configurations. The PT-RS provides a known pilot sequence that is inserted into the OFDM time-frequency grid, allowing the receiver to measure the phase distortion experienced by the data symbols and apply a correction.
Architecturally, PT-RS is a UE-specific reference signal, meaning its configuration—including its density in time and frequency, its scrambling sequence, and its mapping to resource elements—is dynamically scheduled by the gNodeB for each user equipment (UE) based on factors like the scheduled modulation and coding scheme (MCS), the carrier frequency, and the UE's reported capabilities. The signal can be transmitted in both the downlink (from gNB to UE) and uplink (from UE to gNB). In the downlink, it aids UE reception; in the uplink, it assists the gNB in demodulating signals from UEs experiencing significant phase noise. The PT-RS is tightly integrated with other reference signals like the Demodulation Reference Signal (DM-RS) for channel estimation and the Channel State Information Reference Signal (CSI-RS) for channel sounding.
In operation, the gNB configures the PT-RS parameters via Radio Resource Control (RRC) signaling and dynamically activates it via Downlink Control Information (DCI) in the Physical Downlink Control Channel (PDCCH). The PT-RS is typically sparse, with a configurable density (e.g., one PT-RS symbol every 2, 4, or more OFDM symbols in time, and one PT-RS subcarrier per resource block in frequency) to balance overhead against tracking accuracy. The receiver uses linear interpolation or more advanced filtering across these reference points to construct a continuous phase error estimate across the entire scheduled bandwidth and duration. This estimate is then used to de-rotate the received data symbols, correcting for the common phase error (CPE) and potentially the inter-carrier interference (ICI) components of the phase noise.
Its role in the network is foundational for exploiting the full potential of 5G NR's enhanced mobile broadband (eMBB) and ultra-reliable low-latency communication (URLLC) use cases. By mitigating phase noise, PT-RS ensures robust link performance, enabling the use of higher-order modulation for greater data rates and maintaining low block error rates (BLER) for reliability. It is a key enabler for operation in Frequency Range 2 (FR2), supporting the high throughput and connectivity goals of 5G-Advanced networks.
Purpose & Motivation
PT-RS was created to address a fundamental physical layer challenge that became acute with the evolution towards 5G: phase noise impairment. Previous cellular generations (LTE and prior) operated primarily at sub-6 GHz frequencies where phase noise from oscillators was relatively low and could be managed by the inherent robustness of lower-order modulation or averaged out by other reference signals like the Cell-Specific Reference Signal (CRS). However, 5G's expansion into millimeter-wave (mmWave) spectrum, from 24.25 GHz up to 52.6 GHz and beyond, introduced significantly higher phase noise due to the physics of high-frequency local oscillators. Furthermore, the use of advanced multi-antenna techniques (massive MIMO) and wider bandwidths made the system more sensitive to these rapid, random phase fluctuations.
The limitations of previous approaches were clear. Relying solely on DM-RS for phase tracking was insufficient because DM-RS is primarily designed for channel estimation (amplitude and phase of the channel) and is not dense enough in time to track the fast variations of phase noise, especially for long symbol blocks. Without dedicated phase tracking, high-order modulation (e.g., 1024-QAM) would suffer catastrophic error rate increases, negating the spectral efficiency gains. PT-RS solves this by providing a dedicated, configurable pilot signal optimized for tracking the specific characteristic of phase noise—a common phase error across all subcarriers and a frequency-dependent component. Its introduction was motivated by the need to unlock the high data rates and reliable connectivity promised by 5G in its new frequency domains, ensuring that advancements in spectrum and antenna technology were not bottlenecked by this fundamental physical impairment.
What changed in its specifications
The latest release-to-release comparison of specifications that define PT-RS. Each summary describes the whole specification, not only this term.
Rel-19 adds sub-band full duplex base station requirements to TS 38.104, plus LP-WUS text, ATG PUSCH requirements, and the new n110 band. It also adds sub-5 MHz FR1 channel bandwidth requirements and extends wide-area BS unwanted emission limits to n68, n87, n88 and n110.
Full comparison in TS 38.104 →Technology family
MIMO and beam management · Radio Access Network › NG-RAN (5G)
- R99 Transmit diversity, TSTD
- Rel-7 MIMO
- Rel-8 CSI, DM-RS, MU-MIMO, PMI, RI, SDMA, SRS, SU-MIMO, TPMI
- Rel-10 CSI-RS, NZP CSI-RS
- Rel-11 CoMP, CSI-IM, QCL, UL CLTD, UL MIMO
- Rel-13 CRI, FD-MIMO
- Rel-15 Beam Level Mobility, Beam management, BFD, BFD-RS, BFR, PT-RS, TCI, ZP CSI-RS
- Rel-18 CJT
Also in this family (introduction release not pinned to a single defining specification): Beamforming
Members and relations were proposed independently by several models and kept only where at least two agree; quotes are verified verbatim against the specifications. Release = first approved version of the defining specification.
Release Timeline
Detected Changes Across Releases
verified against 3GPP sourcesDocumented changes in 5 releases, each verified against the text of 3GPP specifications or approved change requests and shown with the exact wording. The release timeline above shows the same releases. A release without an entry has no documented change for this term.
PT-RS is specified for the first time in Rel-15: physical-layer mapping and sequence generation, UE reception procedure with time/frequency density tables, DCI port association, and performance requirements with PT-RS.
- “The PUSCH PT-RS shall be mapped to resource elements according to” TS 38.211 v15.10.0
- “5.1.6.3 PT-RS reception procedure” TS 38.214 v15.16.0
- “are used to indicate the association between PTRS port(s) and DMRS port(s)” TS 38.212 v15.13.0
Rel-16 extends PT-RS to two PT-RS ports for PDSCH (multi-TRP), to DCI formats 1_2/0_2, and to uplink port association by DCI, and adds sidelink PSSCH PT-RS mapping.
- “the UE shall receive a single PT-RS port which is associated with the lowest indexed DM-RS antenna port among the DM-RS antenna ports assigned for the PDSCH” TS 38.214 v16.17.0
- “The procedures on PT-RS reception described in this clause apply to a UE receiving PDSCH scheduled by DCI format 1_2” TS 38.214 v16.17.0
- “The PSSCH PT-RS shall be mapped to resource elements according to” TS 38.211 v16.10.0
PT-RS procedures were extended in Rel-17: reception now covers DCI format 4_1 and two-TCI-state PT-RS ports, UL PT-RS port association is signalled for two SRS resource sets, and the MCS tables used for PT-RS time-density are extended.
- “The procedures on PT-RS reception described in this clause apply to a UE receiving PDSCH scheduled by DCI format 1_2” TS 38.214 v17.16.0
- “V=26 for MCS Table 5.1.3.1-4 respectively, the MCS for the PT-RS time-density determination is obtained from the DCI” TS 38.214 v17.16.0
- “Second PTRS-DMRS association – 2 bits if PTRS-DMRS association field and SRS resource set indicator field are present” TS 38.212 v17.13.0
PT-RS behaviour was extended in Rel-18: new EPRE ratio Table 4.1-2A when dmrs-TypeEnh is configured, UL PT-RS port configuration with 8-antenna codebook and multipanel SDM (maxNrofPorts-SDM), and PTRS-DMRS association changes.
- “Table 4.1-2A: PT-RS EPRE to PDSCH EPRE per layer per RE (), if dmrs-TypeEnh is configured in DMRS-DownlinkConfig” TS 38.214 v18.11.0
- “the actual number of UL PT-RS port(s) to transmit corresponding to SRS resource sets is 2.” TS 38.214 v18.11.0
- Correction on PT-RS Coherence Conditions for 8 Tx TS 38.214CR0591
PT-RS behaviour changed: muting resources overlapping PUSCH PT-RS symbols are restricted, PT-RS mapping gains a muting-dependent scaling factor, and PT-RS port determination is extended to 3-antenna-port non-coherent codebooks.
- “the UE is not expected to be configured with muted REs that overlap with any REs occupied by the PT-RS” TS 38.214 v19.5.0
- “the UE does not apply resource muting in the PUSCH symbol containing PT-RS” TS 38.214 v19.5.0
- CR PT-RS with OCC in NR NTN TS 38.214CR0764
Defining Specifications
3GPP specifications that define or reference PT-RS, with the latest known release. Sourced from the 3GPP document catalog — see methodology.
| Specification | Title | Release |
|---|---|---|
| TR 37.910 vj00 | 5G SRIT and NR RIT Self-Evaluation Report | Rel-19 read |
| TR 37.985 vj00 | Overview of V2X features in LTE and NR | Rel-19 read |
| TS 38.104 vk10 | NR Base Station RF Requirements | Rel-20 read |
| TS 38.108 vk00 | NR NTN Satellite Access Node RF Requirements | Rel-20 read |
| TS 38.141 vj40 | BS Conformance Testing (TR 38.141) | Rel-19 read |
| TS 38.181 vj40 | NR Satellite Access Node RF Conformance Testing | Rel-19 read |
| TS 38.211 vj50 | NR Physical Channels and Signals | Rel-19 read |
| TS 38.214 vj50 | NR Physical Layer Data Channel Procedures | Rel-19 read |
| TR 38.802 ve20 | Study on New Radio Access Technology Physical Layer Aspects | Rel-14 read |
| TR 38.820 vg10 | NR; 7-24 GHz Frequency Range Study | Rel-16 read |
| TR 38.833 vh00 | NR Demodulation Performance Enhancement | Rel-17 read |
| TR 38.878 vi40 | Technical Report on Advanced Receiver for MU-MIMO | Rel-18 read |
| TR 38.912 vj00 | Study on New Radio Access Technology | Rel-19 read |
| TS 38.212 vj40 | NR Multiplexing and Channel Coding | Rel-19 read |
| TR 38.808 vh00 | Study on NR above 52.6 GHz to 71 GHz | Rel-17 read |
| TR 38.889 vg00 | NR-based access to unlicensed spectrum study | Rel-16 read |