Description
The Physical Sidelink Shared Channel (PSSCH) is a key physical layer channel defined in 3GPP specifications for sidelink (SL) communication, introduced in LTE Release 12 and continued in 5G NR. Sidelink refers to direct communication between User Equipments (UEs) without the data passing through a base station (eNodeB/gNB) or the core network. The PSSCH is the primary channel used to transport user data (transport blocks) and associated sidelink control information (SCI) between UEs in proximity. It operates in the uplink spectrum for LTE-based sidelink (Mode 3 and 4) and in dedicated or shared spectra for NR sidelink.
The PSSCH transmission involves several physical layer procedures. A transmitting UE first sends Sidelink Control Information (SCI) on the Physical Sidelink Control Channel (PSCCH), which is typically mapped to resources adjacent or nearby to the PSSCH resources. This SCI carries crucial information for the receiving UE to decode the subsequent PSSCH transmission, including resource allocation, modulation and coding scheme (MCS), group destination ID, and timing information. The actual user data is then transmitted on the PSSCH using the resources and parameters indicated by the SCI. The channel utilizes similar modulation schemes (QPSK, 16QAM, 64QAM, 256QAM in NR) and coding (Turbo codes in LTE, LDPC in NR) as other shared channels.
In terms of resource allocation, two main modes are defined for LTE V2X: Mode 3 (scheduled) where the eNodeB allocates sidelink resources, and Mode 4 (autonomous) where the UE autonomously selects resources using a sensing and reservation protocol. NR sidelink introduces more advanced modes with greater flexibility. The PSSCH is fundamental for applications requiring low latency and high reliability, such as vehicle platooning, autonomous driving coordination, and public safety D2D communication. Its design includes features for handling high mobility, half-duplex constraints (a UE cannot transmit and receive on the same frequency simultaneously), and interference management in a distributed environment.
Purpose & Motivation
PSSCH was created to support direct device-to-device communication, a capability essential for new use cases beyond traditional cellular communication. The initial driver in LTE Release 12 was Proximity Services (ProSe) for public safety, allowing first responders to communicate directly when network infrastructure is damaged or unavailable. This addressed a critical limitation of conventional cellular networks, which rely entirely on base station coverage.
The motivation expanded significantly with the introduction of Vehicle-to-Everything (V2X) communication in LTE Release 14. Existing vehicular communication standards like IEEE 802.11p (DSRC) had limitations in scalability, coverage, and integration with cellular networks. PSSCH, as part of the 3GPP V2X standard, was designed to provide a more robust, high-capacity, and network-managed alternative for direct vehicle communication. It solves problems related to high-speed mobility, dense scenarios, and quality of service by leveraging the cellular spectrum and physical layer design. The creation of PSSCH enabled low-latency broadcast, groupcast, and unicast communication between vehicles, pedestrians, and infrastructure, forming the foundation for advanced driving safety and autonomous vehicle coordination.
What changed in its specifications
The latest release-to-release comparison of specifications that define PSSCH. Each summary describes the whole specification, not only this term.
Rel-13 added carrier aggregation requirements, 4Rx antenna port tests, MTC coverage enhancements, LAA test parameters, FD-MIMO procedures, and downlink interference mitigation requirements.
Full comparison in TS 36.101 →Rel-13 added narrowband operation and new MTC and narrowband physical channel terms to TS 36.201.
Full comparison in TS 36.201 →Technology family
Sidelink, D2D and V2X · Services
- Rel-12 EPC-level ProSe Discovery, ProSe, ProSe Direct Communication, ProSe Direct Discovery, PSBCH, PSCCH, PSDCH, PSSCH, Sidelink
- Rel-13 PPPP, ProSe UE-to-Network Relay, Remote UE
- Rel-14 RSU
- Rel-15 PPPR
- Rel-16 NR sidelink communication, PC5 QoS Flow, PQI
- Rel-17 5G ProSe Direct Communication, 5G ProSe Direct Discovery, 5G ProSe Remote UE, 5G ProSe UE-to-Network Relay, NR sidelink discovery, SRAP
- Rel-18 5G ProSe UE-to-UE Relay, NR SL CA, Sidelink Positioning, SL-PRS, U2U Relay UE, U2U Remote UE
- Rel-19 5G ProSe Intermediate UE-to-Network Relay
Members and relations were proposed independently by several models and kept only where at least two agree; quotes are verified verbatim against the specifications. Release = first approved version of the defining specification.
Release Timeline
Detected Changes Across Releases
verified against 3GPP sourcesDocumented changes in 7 releases, each verified against the text of 3GPP specifications or approved change requests and shown with the exact wording. The release timeline above shows the same releases. A release without an entry has no documented change for this term.
PSSCH requirements for UE RF transmission (MPR, A-MPR, time masks, EVM, in-band emissions) and demodulation performance are specified for the first time for ProSe sidelink in TS 36.101.
- “The allowed MPR for the maximum output power for ProSe physical channels PSDCH, PSCCH, PSSCH, and PSBCH shall be as specified in subclause 6.2.3” TS 36.101 v12.31.0
- “The purpose of the requirements in this subclause is to verify the PSSCH demodulation performance with a single active PSSCH link.” TS 36.101 v12.31.0
- “The PSSCH/SRS time mask defines the observation period between sounding reference symbol (SRS) and an adjacent PSSCH symbol and subsequent sub-frame.” TS 36.101 v12.31.0
PSSCH procedures are specified in 36.213: UE configuration with PSSCH resource configurations, transmission of PSSCH using SCI format 0, subframe and resource block determination, plus A-MPR for PSSCH in 36.101.
- “A UE can be configured by higher layers with one or more PSSCH resource configuration(s).” TS 36.213 v13.16.0
- “If the UE transmits SCI format 0 on PSCCH according to a PSCCH resource configuration in subframe n” TS 36.213 v13.16.0
- “the allowed A-MPR for the maximum output power for ProSe physical channels PSDCH, PSCCH, PSSCH, and PSBCH” TS 36.101 v13.25.0
Rel-14 adds V2X procedures for PSSCH: subframe and resource block determination for sidelink modes 3 and 4, a channel-occupancy limit, and UE transmit power (MPR/A-MPR) requirements for PSSCH.
- “14.1.1.4B UE procedure for determining subframes and resource blocks for transmitting PSSCH and reserving resources for sidelink transmission mode 4” TS 36.213 v14.17.0
- “If a UE is configured with high layer parameter cr-Limit and transmits PSSCH in subframe n, the UE shall ensure the following limits” TS 36.213 v14.17.0
- “the allowed MPR for the maximum output power for V2X physical channels PSCCH and PSSCH shall be as specified in Table 6.2.3G.1-1 for power class 3” TS 36.101 v14.27.0
PSSCH resource selection procedures were revised: a new subclause defines the resource subset reported to higher layers for PSSCH in sidelink mode 4, and a CR corrects PSSCH resource pool determination.
- “UE procedure for determining the subset of resources to be reported to higher layers in PSSCH resource selection in sidelink transmission mode 4” TS 36.213 v15.16.0
- Correction on PSSCH resource pool determination in 36.213 TS 36.213CR1225
NR sidelink PSSCH is specified for the first time, covering its transmission in resource pools, association with PSCCH/SCI, symbol and resource block allocation, precoding, antenna ports and transmit power control.
- “Each PSSCH transmission is associated with an PSCCH transmission.” TS 38.214 v16.17.0
- “Only one transmission scheme is defined for the PSSCH and is used for all PSSCH transmissions.” TS 38.214 v16.17.0
- “A UE determines a power PPSSCH(i)P_{\text{PSSCH}}(i) for a PSSCH transmission on a resource pool” TS 38.213 v16.17.0
NR sidelink PSSCH handling was extended in Rel-17: PSFCH priority now follows the smallest PSSCH priority, PSSCH reserved resources can trigger conflict information in PSFCH, and SCI format 2-C was added.
- “If the UE determines a conflict for a reserved resource for PSSCH transmission, the UE provides conflict information in a PSFCH.” TS 38.213 v17.14.0
- “can decode PSSCH according to the detected SCI formats 2-A, 2-B and 2-C, and associated PSSCH resource configuration configured by higher layers” TS 38.214 v17.16.0
- CR on reporting sidelink HARQ-ACK on uplink for SL CG Type 2 PSSCH transmission TS 38.213CR0307
Rel-18 extends PSSCH to shared spectrum channel access, with interlaced RB allocation, CPE starting positions, multi-RB-set transmission and shared SL PRS resource pools, plus corrections to PSSCH-related procedures.
- “for the first SL transmission with PSSCH/PSCCH by a UE to initiate a channel occupancy for a slot” TS 38.214 v18.11.0
- “When PSSCH is transmitted on multiple RB sets, the corresponding PSCCH is located on the sub-channel with the lowest index” TS 38.214 v18.11.0
- “A sidelink resource pool which can be used for transmission of both SL PRS and PSSCH will be referred to as shared SL PRS resource pool.” TS 38.214 v18.11.0
Defining Specifications
3GPP specifications that define or reference PSSCH, with the latest known release. Sourced from the 3GPP document catalog — see methodology.
| Specification | Title | Release |
|---|---|---|
| TS 36.101 vk10 | E-UTRA UE RF Requirements | Rel-20 read |
| TS 36.201 vj00 | LTE Physical Layer General Description | Rel-19 read |
| TS 36.211 vj30 | E-UTRA Physical Layer Specifications | Rel-19 read |
| TS 36.212 vj30 | E-UTRA Physical Layer Procedures | Rel-19 read |
| TS 36.300 vj20 | E-UTRAN Radio Interface Protocol Architecture | Rel-19 read |
| TS 36.302 vj00 | E-UTRA Physical Layer Services | Rel-19 read |
| TS 36.785 ve00 | LTE Sidelink V2V Services Study | Rel-14 read |
| TS 36.786 ve00 | TR on V2X Services based on LTE sidelink | Rel-14 read |
| TS 36.787 vf00 | V2X New Band Combinations for LTE | Rel-15 read |
| TS 36.788 vf00 | V2X Phase 2 Technical Report for LTE | Rel-15 read |
| TS 36.877 vc00 | LTE Device to Device Proximity Services | Rel-12 read |
| TR 37.985 vj00 | Overview of V2X features in LTE and NR | Rel-19 read |
| TS 38.101 vj40 | UE Radio Transmission and Reception; Satellite Access | Rel-19 read |
| TS 38.201 vj00 | NR Physical Layer General Description | Rel-19 read |
| TS 38.212 vj40 | NR Multiplexing and Channel Coding | Rel-19 read |
| TS 38.213 vj50 | NR Physical Layer Control Procedures | Rel-19 read |
| TS 38.521 vj10 | UE Conformance Spec for NR Satellite Access | Rel-19 read |
| TR 38.785 vh00 | UE radio transmission for enhanced NR sidelink | Rel-17 read |
| TR 38.786 vi20 | Technical Report for NR Sidelink Evolution | Rel-18 read |
| TS 38.787 vj00 | UE Radio Transmission for Sidelink CA in ITS Band | Rel-19 read |
| TS 38.793 vj00 | Simultaneous Rx/Tx Band Combinations TR | Rel-19 read |
| TR 38.839 vh00 | Simultaneous Rx/Tx band combinations | Rel-17 read |
| TS 38.863 vk00 | NR NTN RF Coexistence Requirements | Rel-20 read |
| TR 38.868 vh00 | Optimizations of pi/2 BPSK uplink power in NR | Rel-17 read |
| TR 38.881 vi00 | Technical Report on Lower MSD for Inter-band CA/EN-DC/DC | Rel-18 read |
| TR 38.886 vg30 | NR V2X UE Radio Transmission & Reception | Rel-16 read |
| TR 38.889 vg00 | NR-based access to unlicensed spectrum study | Rel-16 read |
| TR 38.894 vi00 | Technical Report | Rel-18 read |